Hi! Need help with EVA 4400 and onboard management module.
EVA firmware 11300000 Build: CR2306lep-11300000
Management module firmware was latest available
The problem;
ABS via this module was work fine via manual IPv4, but i can't access WOCP (module setup and etc). Ok, i try reset management module to reconfigure it. I press reset button on module fort 20+ sec, module reset (LED's blink and down), network port link UPб, status LED on module Green. Module must reset IP to 192.168.0.1/24,no password and etc. Ok ... I try ping 192.168.0.1 = no luck, I try ping OLD module IP = no luck (((.
I try module re-insert, do reset few times via wait 30+ sec, connect direct cross cable to notebook, power-off/on EVA = no luck.
Ok, I install CV 10.3 on server, connect to EVA, CV ask me password from management module, OLD password till reset work ... In EVA = all green and all work, in EVA HW management module status = GOOD, show model number, s/n, Assembly part number, Assembly serial number, Hardware revision ...
I try capture traffic from module, I can see module mac and some IPv6! requests ... but no IPv4
What i can do to recover management module?
Tnx for any help!!!